We use our horse-drawn bale moving wagon regularly on the ranch to move bales!
We purchased the wagon as seen here. It was made by the seller, who assembled components to make a very useable and maneuverable wagon.
It has Gehl running gear and is shortened to a 10-foot bed length. It has a new Pioneer Equipment bench seat and a new Pioneer cast toolbox is bolted on the bed, which was also new lumber when we purchased it. A modern bale spike assembly was mounted on the back, and when we purchased it, it had a high-capacity Warn winch (with remote operation !) mounted on it to run the bale lift mechanism. We replaced the battery-operated winch with a hand-operated come-along to lift the bales. Wedecided to use the winch on another piece of equipment where we could use the high capacity power. The hand operated come along works just fine, however, we’ve considered mounting a smaller battery operated winch to operate the lift mechanism. The wagon with a short wheel base is highly maneuverable which is incredibly helpful in our equipment yard, hay yard, and driveway accessing our covered hay storage.
This side view shows the ‘bale spike’ mounted on the back. This component was purchased and added to the back of the flatbed wagon.
The bale-spike is mounted on the long stringers that support the wagon bed. It is mounted to the stringers and pivots up and down between them, as shown in the photo below. The short spikes on either side of the long spike keep the bale from rotating -stabilizing it.
We use a piece of plastic PVC pipe placed over the long spike to protect people and animals from the pointed spear when it is not being used to carry a bale. The PVC piece is just enough larger than the spike so that it comes off easily just before spearing the bale and goes back on the spike just after the bale is dropped. We always carry the PVC spike cover on the wagon when moving the bale so it can go back on the spike immediately after the bale is dropped.
The spike is set horizontally as the wagon is backed up to spear the bale.
When purchased, the wagon had a large 12-volt battery-operated winch on it. We moved that winch to another piece of equipment and replaced it with a hand-operated come-along.
Doc winches the bale up into a position that will hold it on the spike as he travels. In rough or irregular ground, we go slow, taking it easy so the bale doesn’t get to bouncing, giving special consideration to the horses, who would feel any bounding by the wagon and load.
If you have questions or comments, please feel free to call
Doc 406-250-8252 or email email@example.com, Cathy 406-890-3083 or email firstname.lastname@example.org